Profoto B1X 500 AirTTL 1-Light To-Go Kit - Manual (Page 15)

B1X
15
www.profoto.com
Modeling light settings
The current setting is shown in the Modeling light setting section [19]
on the Display [13].
1. Press the MODEL button [14] to turn the modeling light on or off.
2. With the modeling light on, press and hold down the MODEL
button [14] to toggle between ‘PROP’ and ‘FREE’:
• PROP: The modeling light intensity is automatically adjusted
to be proportional to the selected energy level of the flash light.
• FREE: The modeling light intensity is manually set,
independent from the energy level of the flash light.
3. If ‘FREE’ is selected: With the modeling light on, press and hold
down the MODEL button [14] until the percentage value is blinking.
Turn the ENERGY/SETTINGS dial [16] to change the percentage
value. After a few seconds, the display will stop blinking and the
new value will be set.
Note:
When dimmed the LED modeling light is pulsing and this may trigger some lightmeters. The recommendation is
to turn the modeling light to full power or to turn it off when a lightmeter is used.
Ready signal settings
The current setting is shown in the Ready signal setting section [20]
on the Display [13]:
• BEEP: The unit beeps when it is ready to flash again.
• DIM: The modeling light is turned off after flashing, and is turned
on when it is ready to flash again.
• DIM BEEP: The modeling light is turned off after flashing. The unit
beeps and the modeling light is turned on when it is ready to flash
again.
• Blank: No ready signal.