Philips 439P1 42.5" 4K HDR USB Type-C Docking Monitor - Manual (Page 14)

12
2. Setting up the monitor
Height adjustment
100mm
Warning
• To avoid potential screen damage,
such as panel peeling, ensure that
the monitor does not tilt downward
by more than -5 degrees.
• Do not press the screen while
adjusting the angle of the monitor.
Grasp only the bezel.
2.3 Remove the Base Assembly
for VESA Mounting
Before you start disassembling the
monitor base, please follow the
instructions below to avoid any possible
damage or injury.
1. Extend the monitor base to its
maximum height.
2. Place the display face down on a
smooth surface. Pay attention not to
scratch or damage the screen.
3. Loosen the assembly screws, then
detach the neck from the display.
4
2
1
Note
This monitor accepts a 200mm x 200mm
VESA-Compliant mounting interface.
VESA Mounting Screw M4. Always
contact manufacturer for wall-mount
installation.