Setup – NEC MultiSync E273F-BK 27" 16:9 Full HD IPS Monitor User Manual
Page 19
English−17
English
Setup
For box contents, please refer to the printed contents sheet or setup manual provided in the box.
The accessories included depends on the location where the monitor was shipped.
To attach the base stand to the monitor standN
1. Place monitor face down on a non-abrasive surface (Figure 1).
2. Please rotate the monitor stand 90 degrees as shown in Figure 1.
CAUTIOON
3. Attach the base stand to the monitor stand, then tighten the screw at the
base stand’s bottom (Figure 2).
OOTEN
Reverse this procedure if you need to re-pack the monitor.
AROIONN
.
To connect the monitor to your system, follow these instructionsN
OOTEN:
Make sure to read
“Important Information” on page 3
1. Turn off the power to your computer.
2. Place your hands on each side of the monitor to tilt the panel to a maximum tilt angle and lift up to the highest position
(Figure 3).
Maximum Tilt
Figure 3
Figure 2
Screw
Figure 1
90°