Electrolux 3193-4GA - Manual (Page 36)

Installing and connecting
36
Door Alignment
If necessary, the appliance door can be aligned.
0 First remove the door (see section: "Re-Hanging Door").
0 Using a small screw-driver, lift out the eccentric bearing bushes as
required, above the appliance or below the door, rotate and then press
in according to the figures.
The diagram only shows a right opening door.
For left opening doors please proceed accordingly at the left of the
door at top and/or bottom.
0 Replace the door (see section: "Re-Hanging Door")
Electrical Connection
Any electrical work required to install this appliance should be carried
out by a qualified electrician or competent person.
1 WARNING – THIS APPLIANCE MUST BE EARTHED
The manufacturer declines any liability should these safety measures
not be observed.
Before switching on, make sure the electricity supply voltage is the
same as that indicated on the appliance rating plate. The rating plate is
inside, on the left.
The appliance is supplied with a 13 amp plug fitted. In the event of
having to change the fuse in the plug supplied, a 13 amp ASTA appro-
ved (BS 1362) fuse must be used.