Dell UltraSharp 49 U4924DW 49" WQHD Ultrawide Curved Monitor - Manual (Page 48)

48
│
Setting up the monitor
Connecting the monitor for RJ45 Cable (Optional)
NOTE: RJ45 cable is non in-box standard accessory.
Connecting the super speed USB 10 Gbps (USB 3.2 Gen2) cable
NOTE: To prevent data damage or loss, before unplugging the USB
upstream port, make sure that NO USB storage devices are in use by
the computer connected to the monitor’s USB downstream port.
After you have completed connecting the DisplayPort/HDMI/USB Type-C cable,
follow the procedures below to connect the USB cable to the computer and
complete your monitor setup:
1. a. Connect one computer: connect the USB 3.2 (Gen2) Type-C upstream
port (data only) (cable supplied) to an appropriate USB 3.2 (Gen2) port on
your computer.

b. Connect two computers*: connect the USB 3.2 (Gen2) Type-C
upstream port (data only) (cable supplied) and USB Type-C upstream port
(video and data) (cable supplied) to appropriate USB ports on the two
computers. Then use the OSD menu to select between the USB upstream
source and input sources. See
USB .
2. Connect the USB peripherals to the USB downstream ports on the monitor.