Dell UltraSharp 49 U4924DW 49" WQHD Ultrawide Curved Monitor User Manual
Page 28
28
│
About your monitor
Driver Installation
Install the Realtek USB GBE Ethernet Controller Driver available for your system.
This is availab
monitor model
number in the
Search
bar to identify the product, and then find the software under
Drivers & Downloads
section.
Network (RJ45) data rate through USB-C max speed is 2500 Mbps.
Computer power
save state
Computer behavior after receiving Wake-on-LAN
(WOL) command
Modern Standby
(S0ix)
Computer and Monitor remain in Standby but network
communication enabled.
Standby/Sleep (S3)
Both Computer and Monitor turned ON.
Hibernate (S4)
Both Computer and Monitor turned ON.
OFF/Shutdown (S5)
Both Computer and Monitor turned ON.
Wake-on-LAN behavior
NOTE: The computer BIOS must be configured to enable WOL function
first.
NOTE: This LAN port is 1000Base-T IEEE 802.3az compliant,
supporting Mac Address (Printed on model label) Pass-thru (MAPT),
Wake-on-LAN (WOL) from standby mode (S3 only) and UEFI* PXE
Boot function [UEFI PXE Boot is not supported on Dell Desktop PC’s
(except for OptiPlex 7090/3090 Ultra Desktop)], these 3 features
depend on BIOS settings and version of the OS. Functionality may vary
with non-Dell PC’s.
*UEFI stands for Unified Extensible Firmware Interface.
NOTE: WOL S4 and WOL S5 only capable with Dell Systems that
support DPBS and is with USB-C connection only.
NOTE: Any issue related to WOL, user should debug the computer
without monitor. After the problem is solved, then connect to the
Monitor.