Building over a kitchen unit with door, 3fitting the hob to the worktop – Electrolux 69802 G User Manual
Page 16
16
Building over a kitchen unit with door
Proper arrangements must be taken in
designing the furniture unit, in order to
avoid any contact with the bottom of the
hob which can be heated when it is
operated. The recommended solution is
shown in diagram 3.
The panel fitted under the hob ("a")
should be easily removable to allow easy
access if technical assistance is needed.
The space behind the kitchen unit ("b")
can be used for connections.
30
20 min
60
a
b
FO 1013
3
Fitting the hob to the worktop
Before fitting the hob into the cut out,
an adhesive seal must be fitted to the
underside outside edge of the hob. It
is essential that no gaps are left in this
seal in order to prevent spillage near
the hob seeping into the cabinet
below.
1) Remove the pan supports, the
burners caps and crowns and turn
the hob upside down, taking care
the ignition candles are not
damaged in this operation.
2) Place the sealing gasket all
around the glass top edge as
shown in the diagram.
3) Fit the hob in the cut out and push
it down until the glass top and the
working top make contact, as
shown in the diagram.
A
FO 2108
FO 2107
A) Sealing gasket
Dimensions are given in mm.
)
)
)
)
)
Instructions for the Installer