Acer CB382CUR 37.5" 1600p Curved Display - Manual (Page 29)

1. Press the MENU key to open the OSD.
2. Toggle the joystick to the up or down to select System from the OSD.Then toggle to the
right to navigate to the element you wish to adjust and press the joystick to enter it.
3. Toggle to the left or right to adjust the sliding scales.
4. Input: Select the source from DP In, HDMI 2.0 or DP ALT.
5. Auto Source:The default is “On”, can support auto search for signal source in order.
6. Wide mode: You can select which screen aspect you are using. The options are Full,
Aspect, and 1:1.
7. PIP/PBP settings
8. Hot key Assigment: Select the function of shortcut key 1(Modes, Brightness, Volume,
Gamma, Contrast, Blue Light, Over Drive, VRB, PIP/PBP) and shortcut keys 2 (Modes,
Brightness, Volume, Gamma, Contrast, Blue Light, Over Drive, VRB, PIP/PBP)
9. DDC/CI: Allows the monitor settings to be set through the software on the PC.
---------------------------------------------------------------------------------------------------------
Note: DDC/CI, short for Display Data Channel/Command Interface, which
allows monitor controls to be sent via software.
10. HDMI Black level setting.
11.
Quick start mode: Select Off or On. Turn on to speed up boot speed.
12. DP ALT Mode: Default set USB 3.0 function OFF. Turn on USB 3.0 function, Using
higher speed for data transport, display port only occupy on two lanes.
On: Using 2 lanes for USB 3.0 high speed data and 2 lanes for DisplayPort signal.
DP ALT maximum display resolution is QHD (3440x1440-30Hz).
Off: Using full lanes to transport DisplayPort signal.
13. Power-off USB charge: Turn On or Off.
---------------------------------------------------------------------------------------------------------
Note: To comply with international power standards , the Power off USB charge
is set to off by default, The sleep mode cannot be resumed under the USB
Type-C input. To wake up from sleep (via PC), the user needs to change the
Power off USB to on.