beautypg.com

Safety instructions – Erica Synths Black Dual ASR EG Eurorack Module User Manual

Page 2

background image

EG/LFO time configuration.

A module has two timing configurations –

short and three times longer. The factory

preset configuration is the long one. If you

prefer the short setting, simply remove two

jumpers on the back of the module. You may

wish to have one EG configured for short time

and other for a long one – then remove just

one of jumpers.

Transport the instrument carefully, never let it drop or fall

over. Warranty does not apply to modules with visual

damages.
The module has to be shipped in the original packaging

only. Any module shipped to us for return, exchange and/or

warranty repair has to be in its original packaging. All other

deliveries will be rejected and returned to you. Make sure

you keep the original packaging and technical documentation.
This device complies to the EU guidelines and is manufac-

tured RoHS conforming without use of lead, mercury,

cadmium and chrome. Nevertheless, this device is special

waste and disposal in household waste is not recommended.

User manual by Girts Ozolins@Erica Synths.

Design by Ineta Briede@Black8.

Copying, distribution or any commercial use in any way is

prohibited and needs the written permission by Erica Synths.

Specifications are subject to change without notice.In case of

any questions, feel free to contact us through www.erica-

synths.lv.

You will find Erica Synths terms of warranty at

www.ericasynths.lv

Items for return, exchange and/or warranty repair have to

be registered at SUPPORT on www.ericasynths.lv and send

back to us according to instructions in the support page.

SAFETY INSTRUCTIONS

Please follow the instructions for use of the Erica Synths module below,

‘cause only this will guarantee proper operation of the module and

ensure warranty from Erica Synths.

Water is lethal for most of the electric devices, unless they are made

waterproof. This Erica Synths module is NOT intended for use in a

humid or wet environment. No liquids or other conducting

substances must get into the module. Should this happen, the

module should be disconnected from mains power immediately,

dried, examined and cleaned by a qualified technician.

Do not expose the module to temperatures above +50° C or below

-20° C. If you have transported module in extreme low temperatures,

leave it in room temperature for an hour before plugging it in.

Remove the jumpers

for short EG/LFO

configuration.