SPL Iron V2 Two-Channel Tube Mastering Compressor (Black/Silver) - Manual (Page 26)

26
Security Advices
If you notice any abnormality
When one of the following problems occur, immediately turn off the power switch and dis-
connect the electric plug from the mains socket outlet. Then have the device inspected
by a qualified professional.
• The power cord or plug gets frayed or damaged.
• The device emits unusual smells or smoke.
• An object has fallen into the unit.
• There is a sudden loss of sound during the use of the the device.
Caution
Always follow the basic precautions listed below to avoid the possibility of physical injury
to you or others, or damage to the device or other property. These precautions include,
but are not limited to, the following:
Power supply/Power cord
When removing the electric plug from the device or an mains socket outlet, always pull
on the plug itself and not the cord. Pulling the cord may damage it.
Unplug the device from the mains socket outlet when the device is not used for a while.
XLR output connector
Touching the open pins of the XLR output connector may result in an uncomfortable
feeling.
Location
Do not place the device in an unstable position where it might accidentally fall over.
Do not block the vents. This device has ventilation holes to prevent the internal tempera-
ture from rising too high. In particular, do not place the device on its side or upside down.
Inadequate ventilation can result in overheating, possibly causing damage to the device
or even fire.
Do not place the device in a location where it may come into contact with corrosive gases
or salty air. This may result in malfunction.
Before moving the device, remove all connected cables.
When setting up the device, make sure that the mains socket outlet you are using is easily
accessible. If some trouble or malfunction occurs, immediately turn off the power switch
and disconnect the plug from the mains socket outlet. Even when the power switch is
turned off, electricity is still flowing to the product at a minimum rate. When you are not
using the device for a long time, make sure to unplug the power cord from the wall mains
socket outlet.
Connections
Before connecting the device to other devices, power down all devices. Before power on
or off the devices, set all volume levels to minimum.
Only use appropriate cables to connect the device with other devices. Make sure that the
cables you use are intact and comply with the electrical specifications of the connection.
Other connections can lead to health risks and damage the equipment.