SPL DMC Mastering Console (Black) - Manual (Page 19)

17
Control Elements
Recording Gain On
If the Recording Gain button is activated, the Recording Gain control is in the signal path.
Mono
By using the Mono button, the input signal can be switched from mono to stereo. If the
button is activated, the mono signal is also at the Insert and Recording Out.
Insert
With the Insert button you can activate the Insert to loop external hardware. When the
Insert button is activated, the signal is sent by the Insert Send and returned to the DMC by
the Insert Return.
Insert Return Trim L / Insert Return Trim R
With the buttons Input Return Trim L and Input Return Trim R you can increase or attenuate
the Returns signal in the input section up to 6dB. If the switch (11) is in the center position
(0 dB) the respective Input Return Trim is not influencing the signal flow.
Insert Return Trim -0+ Switch
This switch determines if the level at the respective Insert Trim is attenuated (-) or
increased (+) or (in the center position = 0 dB) stays unmodified when passing the Insert
Return Trim section.
Sources (1-4)
With the four buttons of the Sources section, you can select between the four differ-
ent stereo inputs of the category Sources. This selected source can only be monitored
with the monitor section of the DMC. Only one button can be activated in this section. If
another button is pushed, this button is activated. A multiple selection is not possible.
The current selection is visualized by the button lighting up. The signal CAN‘T be played
with the Insert or the Recording Outputs.
Source
With the button Source you can toggle between the inputs of the Source and Input sec-
tion. Thanks to this it is possible to (for example) toggle between an input signal pro-
cessedthroughtheInsertandafinalMasteroftheDAWbypushingabutton.