Top panel controls – Samson MIXPAD MXP124FX Analog Stereo Mixer with Effects and USB User Manual

Page 15

MXP124/MXP124FX

ENGLISH

FRANÇAIS

DEUTSCHE

ESP

AÑOL

ALIANO

Master Section

This following section details the master section of the mixer.

21. TAPE IN (RCA jacks) - Stereo line

level input, on RCA connectors,
for connecting the output of
devices such as MP3, CD,
computer sound-card, or any
other line level device.

22. TAPE OUT (RCA jacks) - The signal present at this connector is the MAIN

bus signal before it has passed through the MASTER level control and
graphic equalizer. The nominal output level is -10dBV and the impedance
is 100 Ohms.

23. MIX 2 - These line level MIX 2 outputs can be used to drive a second

speaker system or connect to a stereo device such as computer sound
card, MP3, or recorder. The signal at the MIX 2 jacks follows the MIX 2
level control knob allowing you to set a different level at the outputs.

24. MAIN MIX - The MAIN MIX ¼” jacks can be connected to a power

amplifier, powered speaker system, or inputs of a digital recorder. The
signal at the MAIN OUT jacks follows the MAIN volume fader.

25. FX SEND (MXP124FX) - The signal present at the FX

SEND output is sent from the FX bus, which is fed from
the FX send on the input channels.

MON SEND (MXP124) - The signal present at the MON
SEND output is sent from the MON bus, which is fed
from the MON send on the input channels.

26. PHONES Output - Connect standard ¼” TRS stereo headphones, 60 to 600

Ohms. The PHONES output level is controlled by the MIX 2/PHONES
control.

27. POWER Indicator - The POWER LED lights up to

indicate that the main POWER switch (located on the
rear panel) is on.

28. Output Level Meter - The output level meter allows you

to monitor the level of the signal, which is being sent
to the MAIN MIX jacks.
NOTE: To avoid distortion, adjust the MAIN MIX level
control so that the 0 indicator LED lights occasionally.

Top Panel Controls