Samsung HW-S60B 5-Channel Soundbar - Manual (Page 14)

ENG - 14
(Sound Control)
By pressing the button, you can set the audio function. The desired item can be adjusted using the Up /
Down buttons. Each time the mode changes, the Multicolor LED blinks in white.
LED
Indicator
White Blinks X1
“ SpaceFit Sound ”  “ Active Voice Amplifier ”  “ Voice enhancement ”  “ Night
mode ”  “ Sync ”  “ Virtual ”
– Press and hold the (Sound Control) button for about 5 seconds to adjust the sound for each
frequency band. 150Hz, 300Hz, 600Hz, 1.2kHz, 2.5kHz, 5kHz, and 10kHz are selectable using the Left/
Right buttons and each can be adjusted to a setting between -6 to +6 using the Up/Down buttons.
(Make sure the Sound mode is set to " Standard ".)
– “ Voice enhancement ” makes it easier to hear spoken dialog in movies and TV.
– “ Night mode ” is optimized for night time viewing with the settings adjusted to bring the volume
down but keep the dialog clear.
– If the video on the TV and audio from the Soundbar are not synchronized, select “ Sync ” in Sound
Control, and then set the audio delay between 0~300 milliseconds by using the Up/Down buttons.
– “ Sync ” is only supported for some functions.
– The “ Virtual ” function can be turned On/Off by using the Up/Down buttons.
Bluetooth PAIR
Switch the Soundbar to Bluetooth pairing mode.
When you press the button, the LED display changes as shown below.
• Until pairing is complete, the Multicolor LED changes as Red → Green → Blue in turn.
LED
Indicator
Red → Green → Blue Blinks
Pairing Connection is complete
Cyan Blinks X3
“ Ready to connect via Bluetooth. ”
p (Play / Pause)
You can also play or pause music by pressing the button.