Roborock H6 CE - Manual (Page 11)

Buttons
7
Sustain Button
Press the Sustain button to enter Sustain mode. The Sustain icon will appear on screen. Squeeze the trigger while in Sustain
mode to start the vacuum and enable it to run continuously. In Sustain mode, the vacuum will not stop when the trigger is
released. Press the Sustain button again to disengage Sustain mode and stop vacuuming.
You can also enable the vacuum to run continuously by first pressing the trigger then pressing the Sustain button.
Notes:
1. Squeezing the trigger while the vacuum is already running continuously in Sustain mode will have no effect.
2. Pressing the Sustain button for 2 seconds in any active mode will stop the vacuum.
Mode Switch button
When the vacuum is on, press the Mode button to switch between Eco, Standard, or MAX modes. The respective icon will be
highlighted on-screen.
Note:
The vacuum will return to Standard mode after turning off or when charging.
Trigger
Squeeze the trigger to start vacuuming.
* Press the Sustain button while the vacuum is running continuously to disengage Sustain mode.
Releasing the trigger will stop the vacuum and enter it into Standby mode, unless it is in Sustain mode. The screen will turn off
automatically after 30 seconds of inactivity and the vacuum will automatically turn off after 1 minute of inactivity.
Notes:
1. The vacuum will stop running when charging.
2. Insufficient power or other errors may cause the vacuum to fail. See Troubleshooting for details.