Roborock Q5+ - Manual (Page 11)

12
Basic Parameters
Robot
The serial number is on a sticker on the underside of
the robot.
Note:
Q340RR Model
14.4V/5200mAh
lithium-ion battery
Battery
Approx. 3.2kg (7.05 lbs. ) Weight
< 6 hours Charging Time
Rated Input 20V 1.2A
Errors
If an error occurs while the robot is cleaning, the
power indicator will flash red quickly, and a voice
alert will sound. Refer to the following table for
troubleshooting.
1. After resolving any of the following errors, relocate
your robot and restart cleaning.
2. After any sensor errors, clean the sensor and retry.
3. If the battery is at an abnormal temperature, wait
for it to return to normal before use.
Error 1:
LiDAR turret or laser blocked. Check
for obstruction and retry.
Error 2:
Bumper stuck. Clean it and lightly tap
to release it.
Error 3:
Wheels suspended. Move robot and
restart.
Error 4:
Cliff sensor error. Clean cliff sensors,
move robot away from drops and restart.
Error 5:
Main brush jammed. Clean main brush
and bearings.
Error 6:
Side brush jammed. Remove and clean
side brush.
Error 7:
Wheels jammed. Move the robot and
restart.
Error 8:
Robot trapped. Clear obstacles
surrounding robot.
Error 13:
Charging error. Clean charging
contacts and retry.
Error 9: No dustbin. Install dustbin and filter.
Error 12: Low battery. Recharge and retry.
Error 14: Battery error.
Error 26: Wall sensor dirty. Clean wall sensor.
Error 16:
Robot tilted. Move to level ground and
restart.
Error 21:
Vertical bumper pressed. Move robot
and retry.
Error 23:
Could not return to dock. Clean dock
location beacon and retry.
Filter blocked or wet. Clean, dry, and retry.
No-go zone or Invisible Wall detected. Move
robot from this area.
If the problem persists after using the
recommendations in the table above, contact our
support team at:
[email protected] (United States/Canada/
Non-Europe)
1-855-960-4321 (United States only)
1-833-421-1915 (Canada only)
Note: A system reset may resolve some problems.
Internal error. Reset the robot.
Error 22: Dock locator error. Clean and retry.
Error 17: Side brush error. Reset robot.
Error 18: Fan error. Reset robot.
pack casing to avoid short-circuits or leakage of hazardous
substances.
• In the event of accidental contact with battery fluid, rinse
thoroughly with water and seek immediate medical care.
50-60Hz
9.5A
0.5A
20V 1.2A
Rated Input (Dust Collection)
Rated Input (Charge)
Rated Output
Auto-Empty Dock
AED03LRR, AED04LRR Model
120V~ Rated Input Voltage
Rated Frequency
Charging Battery
14.4V/5200mAh
lithium-ion battery