Roborock Q5+ - Manual (Page 10)

11
C6
Dust Bag Replacement
* Replace as required.
C7
Air Duct
* Clean as required.
Note: To prevent blockage, only use clean water without any
cleaning liquid.
C5-3— Rinse the dustbin with water.
Note: Do not touch the surface of the filter with your hands,
brush, or hard objects to avoid potential damage.
C5-4— Rinse the filter repeatedly and tap it
to remove as much dirt as possible.
C5-5— Allow 24 hours for the dustbin and
filter to dry thoroughly and reinstall them.
Note: Purchase an additional filter and alternate if necessary.
Note: The dust bag handle seals the bag on removal to prevent
dust leakage.
C6-1— Remove the dustbin cover vertically
as shown.
C7-1— Unscrew the screws (10) and remove
the cover.
C7-2— Wipe the air duct and cover with a
dry cloth.
C7-3— Re-install the cover and screw it back
in place.
C6-2— Lift the dust bag out of the dustbin
and discard it.
C6-4— Install a new dust bag in place along
the slot and put the dustbin cover back.
C6-3— Clean the filter with a dry cloth.
Use a soft, dry cloth to wipe and clean all
sensors, including:
C8 Robot Sensors
* Clean monthly.
C8-1—Dock Locator
C8-2—Wall Sensor
C8-3—Cliff Sensors
Use a soft dry cloth to wipe the charging
contacts on the robot. Clean the dock
location beacon, charging contacts, and
electrode brushes on the dock .
C9 Charging Contact Areas
* Clean as required.
The robot is equipped with a built-in high-
performance lithium-ion rechargeable
battery pack. To maintain battery performance,
keep the robot charged during normal use.
Battery
Note: If the robot will be left unused for a long period, turn it
off and charge it at least every three months to avoid battery
damage caused by over-discharge.
C5
Dustbin and Washable Filter
* Clean every week. Filter should be replaced every 6-12 months.
C5-1— Take out the dustbin.
C4
Main Wheels
* Clean monthly.
Clean the main wheel with a soft, dry cloth.
C5-2— Remove washable filter and empty
the dustbin.
C3-2— Rinse the wheel and the axle with water
to remove any hair and dirt. Dry and reattach
the wheel, pressing it firmly in place.
The chemical substances contained in the
built-in lithium-ion battery of this product
can cause environmental pollution.
Before disposing of this product, remove
the battery. The battery should then be
properly recycled either through local
authorities or by providing the batteries to a
battery recycling facility.
How to remove the battery:
Environmental protection
description
The following information applies only when disposing
of the robot or if the battery is no longer functioning normally.
You will be able to recognize this problem if, even when left to
charge, the robot cannot clean due to a low battery. Do not
remove the battery if you intend to continue using the robot.
Notes:
Note:
• Before removing the battery, make sure it is fully drained.
Do not attempt to remove the battery if the robot is
connected to the charging dock.
• Remove the entire battery pack. Avoid damaging the battery
1. Turn off the robot.
2. Unscrew the battery cover.
3. Remove the battery cover.
4. Press the clip to pull out the battery
connector.
5. Remove the battery.