Emprex LCD Monitor LM-1905 - Manual (Page 12)

4.The side effect of the Monitor Life-Extension function (why not
preset Advanced Power Saving Mode as default?)
According to the request of EPA (US Environmental Protection Agency) to power
management of monitors, the power consumption of the monitor must go down to below
3 watts within 3 seconds after the monitor steps in power saving mode. But the
Life-Extension function decreases the electricity supplied to the backlights of LCD
monitor gradually. Therefore, the Monitor Life-Extension function has conflict with the
requirement of EPA in the first 7 minutes after entering sleeping mode. Even
though,comparing the advantages of both conditions, we still recommend you strongly
to set your monitor in Advanced Power Saving mode.
5. l How to engage the Monitor Life-Extension function?
You may simply use the OSD control to activate the Monitor
Life-Extension function.
1.This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions (1) this device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation.
2.NOTE: This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation, If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
3.Reorient or relocate the receiving antenna.
4.Increase the separation between the equipment and receiver.
5.Connect the equipment to an outlet on a circuit different from that to which the receiver
is connected.
6.Consult the dealer or an experienced radio/TV technician for help.
- 9 -
1. Press the Menu button to activate the OSD menu.
2. Press or button to select the POWER SAVING MODE icon
3. Press the Menu button to confirm the selection.
4. Press or button to select the ADVANCED option in the
POWER SAVING MODE function.
5. Press the Menu button to confirm the selection .
6. Press or button to select the EXIT icon
7. Press the Menu button to exit the OSD menu .
WARNING:
FCC compliance
Any unauthorized modification to this equipment could result in
the revocation of the authorization to operate the equipment and
void the product warranty.