Roborock S8+ CE - Manual (Page 11)

11
If the robot fails to find the dock, it will automatically
return to its starting location. Place the robot on the dock
manually to recharge.
Note:
Restore Factory Settings
If the robot does not function properly after
a system reset, switch it on. Press and hold
the button and at the same time, press
the Reset button until you hear the
“Restoring factory settings” voice prompt.
The robot will then be restored to factory
settings.
System Reset
If the robot does not respond when a
button is pressed or cannot be turned off,
reset the system. Press the Reset button,
and the robot will reset automatically.
Note: After resetting the system, scheduled cleaning, WiFi,
etc. will be restored to factory settings.
Error
If an error occurs, the power indicator
light on the robot will flash red or status
indicator light on the dock will be steady
red. A pop-up notification will receive in
the app and a voice alert may sound.
Notes:
• The robot will go to sleep automatically if left in a
malfunctioning state for over 10 minutes.
• Placing a malfunctioning robot on the dock manually will
end the current cleanup.
the robot back to the dock. The power
indicator will pulse as the robot charges.
C1
Main Brushes
C2
Side Brush
* Clean every 2 weeks and replace every 6-12 months.
C1-1—Main Brush
C1-2—Main Brush Cover
C1-3—Latches
C1-4—Main Brush Bearing
C1-5—Main Brush Caps
C1-6— Turn over the robot and press the
latches to remove the main brush cover.
Remove the main brush and pull out
the main brush bearing.
Pull out the main brush caps.
After removing the tangled hair or dirt
at both ends of the main brush,
reinstall it, press on the main brush
cover to lock it in place.
Use a tool, such as a small screwdriver,
to pry out the axle and take out the
wheel.
C1-8—
C1-9—
Notes:
• Main brush should be wiped down with a wet cloth and
left to dry away from direct sunlight.
• Do not use corrosive cleaning fluids or disinfectants to
clean the main brush.
1. Unscrew the side brush screw.
2. Remove and clean the side brush.
Reinstall the brush and tighten the screw.
* Clean monthly and replace every 3-6 months.
C3
Omnidirectional Wheel
The omnidirectional wheel bracket cannot be removed. Note:
C3-1—
* Clean as required.
C1-7—
Rinse the wheel and the axle with
water to remove any hair and dirt.
Dry and reattach the wheel, pressing
it firmly in place.
C3-2—
Open the top cover of the robot and
take out the dustbin.
Open the dustbin cover and remove
the filter, then empty the dustbin.
Fill the dustbin with clean water and close
the cover. Gently shake the dustbin, and
then pour out the dirty water.
Leave the dustbin and the washable
filter to dry.
Clean the main wheels with a soft, dry cloth.
C4
Main Wheels
C5
Dustbin
* Clean monthly.
C5-2—
C5-1—
* Clean as required.
Note: To prevent blockage, only use clean water without any
cleaning liquid.
C5-3—
C5-4—
Routine
Maintenance
C
Open the filter cover and remove
the filter.
C6
Washable Filter
* Clean every 2 weeks and replace every 6-12 months.
C6-1—
Purchase an additional filter and alternate if necessary.
Rinse the filter repeatedly and tap it
to remove as much dirt as possible.
Allow 24 hours for the filter to dry
thoroughly and reinstall it.
Note: Do not touch the surface of the filter with your hands,
brush, or hard objects to avoid potential damage.
Note:
C6-3—
C6-2—