Sharp PN-60TA3 - Manual (Page 7)

13. Scanner settings
(Network Scanner Tool Lite)
(1) Touch “NST-Lite Setup” on “BASIC Setting” tab.
(2) Touch “Scanners” tab.
(3) Touch “Auto Detect” to automatically find scanners.
(4) Check scanners from which you want to scan.
You can confirm scanners’ IP address from
“Properties” to identify them.
(5) Touch “Apply” to save profile to the scanner.
Then touch “OK” to close.
(6) Finally, check “Scan Folder” on “Admin Settings” tab.
If you close the setting, go to the step 10.
Before the installation of the scanner, please confirm that the
white board connected to the same network.