Echo PB-620 - Manual (Page 4)

4
C
RUISE
C
ONTROL
K
IT
I
NSTALLATION
I
NSTRUCTIONS
7. Place rear half of split clamp over spark plug lead, and press clamp on
mounting screw boss in blower housing.
8. Place fuel/return lines in throttle cable/fuel line clamp (F):
• Place clear fuel return line in small recess
• Place black fuel line in large recess, in front of clear fuel return line
9. Adjust throttle cable nut position, and place nut in hex-shaped recess in
clamp:
• Set cruise control button (S) to Wide Open Throttle position
• Pull down on throttle cable conduit until throttle plate on carburetor
pivots to WOT position. Hold cable in position until throttle cable
nut is adjusted and placed in clamp.
• Adjust throttle cable nut to align with recess in clamp, and place nut
in clamp to hold WOT position.
• Place front half of split clamp over fuel lines and throttle cable, and
secure with clamp screw.
NOTE
Make sure fuel lines and throttle cable are properly seated in clamp, and
are not pinched during assembly
10. Place plastic cable tie (G) around fuel lines and throttle cable, but do not
draw tight. Carefully cut off excess end of cable tie.
11. Gather ignition leads around coupler, and secure coupler to spark plug
lead and throttle cable with cable tie. Trim excess end of cable tie.
S
F
G