Settings mode, Selecting and saving settings, Transpose – Kurzweil CUP110 User Manual
Page 17: Reverb level
page 11
Settings Mode
The Settings Mode includes parameters that allow you to change the overall behavior of the entire instrument.
The following parameters are available in Settings Mode:
● Transpose
● Reverb Level
● Touch Sensitivity
● Tune
● MIDI Channel
● Metronome Volume
● Local Control
● Auto Power Off
● Hard Reset
● OS/Object
Selecting and Saving Settings
Press the Settings
button to enter Settings Mode. Pressing the Settings button repeatedly allows you to choose
one of the parameters listed above. Once you choose a parameter, you will use the Prev- or Next+ buttons to navi-
gate the values of that parameter. Pressing the Voice or Piano button will exit this mode.
Transpose
The Transpose parameter allows you to adjust the overall pitch of the keyboard up or down in semitone intervals.
Press the the Settings button until the screen displays Transpose: (0 is the factory default). To transpose the pitch
up, press the
Next+ button for each semitone up in pitch. To lower or transpose down, Press the Prev- button to
lower the semitone pitch.
Pressing the Prev- / Next+ button pair will reset the transposition back to factory default of
0. The transposition has a range of -24 to +24. This offers a two octave transposition range up or down.
Reverb Level
The reverb level parameter controls the level of the reverb effects used on a voice. Press the Settings button until
the screen reads REVERB LEVEL:20 (factory default). To increase the reverb effect, press the Next+ button. To
decrease the reverb effect press the Prev-
button. You can adjust the effect level from 0% (no effect) to 100%. Press-
ing the Prev- / Next+ button pair will reset the effect level back to factory default of 20%.