KORG LP-380-73 - Manual (Page 17)

17
The 73-key version has four screws (M4). In addition,
the push rivet is not included.
Screws (M6) x 6 pcs. Screws (M4) x 8 pcs. Caps x 6 pcs.
Push rivet x 1 pc. Cord holder x 1 pc.
3. Fasten the LP-380 and the speaker box to the right and left
side panels using eight screws (M6).
Position the speaker box so that the speaker cord is on the left
side. In this position, the speaker (the side covered with cloth)
faces you.
First temporarily tighten* the screws on the right side panel,
and then temporarily tighten* the screws on the left side pan-
el.
* To temporarily tighten the screws is to tighten them leav-
ing a clearance of about 2 mm.
LP-380
the side covered with cloth
Speaker box
Screws
(M6)
Screws
(M6)
Side panel (right)
Side panel (left)
Positioning tab
Be careful not to pinch your fingers.
4. Connect the attached pedal cord, observing the correct ori-
entation, to the connector on the reverse side of the pedal
unit, and then engage it with a slot in the pedal unit.
The pedal cord can be attached to or detached from the con-
nector with its locking tab held down.
The pedal unit for the 73-key version has a different
shape, but is prepared in the same way.
Locking
tab
88-key version
73-key version
Assembling the Stand
Warning
● At least one other person must help you assem-
ble the stand.
Caution during assembly
In order to assemble the stand safely, please observe the follow-
ing points.
• Make sure that you have the correct part in the correct orien-
tation, and perform the assembly in the order given.
Other cautions
Please check the following points after assembly.
• Loosened screws
The screws may loosen as time passes after assembly. You
should periodically check whether any screws have become
loose. If you feel that the stand vibrates excessively, it is pos-
sible that screws have come loose. If so, re-tighten them.
• When moving the digital piano to another location
To move the assembled stand, remove the AC adapter cord
from the stand, close the key cover, and then move it slowly
with at least two people keeping it as level as possible.
• Disassembly
If you need to disassemble the stand, do so by reversing the steps
of the assembly procedure. After disassembly, keep the screws
and other parts in a safe place so that they are not lost.
The LP-380 should always be laid down before disas-
sembled.
Assembly procedure
You’ll need a Phillips (+) screwdriver.
1. Put the protective sheet, which had covered the LP-380, on
a flat floor, and place the LP-380 on that sheet with its rear
facing the floor.
In addition, place cloths or magazines so that you may easily
put your hands under the LP-380 when assembling and rais-
ing the stand.
Ensure that the LP-380’s key cover will not to open until
the end of the assembly.
Protective sheet
LP-380
2. Make sure that all of the following parts are available.
The 73-key version does not have a pedal board. In ad-
dition, the hardware for installing the pedal board is
not installed on the inside of the side panels.
Anti-tipping Bracket (left) Anti-tipping Bracket (right)
Pedal unit
Pedal board
Speaker box
Side panel (right) Side panel (left)
Pedal cord