Electrolux 726662 - Manual (Page 15)

15
Before using the appliance, clean the chamber with a detergent
solution, as there may still be condensation in the chamber left
over from the final testing by the manufacturers (see section D.1
for further information).
C.2.1 SWITCHING ON
Switch on the fused disconnet switch or the main circuit breaker
switch and press the I = ON button to start the appliance. The
I = ON indicator light lights up to signal that the appliance is
powered up.
C.2.2 OPERATION
C.2.2.1 Starting a “cruise chilling” cycle
To start the automatic “cruise chilling” (positive) cycle, insert
the core probe in the product and press the button .
The cycle starts immediately when activated. To stop it, keep
the button pressed for at least 3 seconds.
IMPORTANT: The “cruise chilling” cycle is not
activated when the appliance is in “programme selection”
status
.....
C.2.2.2 Selecting a standard cycle
The default setting on the appliance is the SOFT chilling cycle.
Use these buttons to select one of the following
options:
From left to right:
• Positive "SOFT CHILLING"
• Positive "HARD CHILLING"
• Positive "COOLER" maintenance (or preservation)
• Negative "BLAST FREEZING" chilling or freezing
• Negative "FREEZER" maintenance (or preservation)
When choosing a cycle, press the button to move on to the
next option; the options are in a loop and so you can either scroll
forwards or backwards .
If you want another cycle, keep pressing the button until
the indicator light for the chosen cycle turns orange, and start it
by pressing the button.
IMPORTANT:The appliance recognizes automatically when the
food (core) probe is inserted in to the product. If the probe hasn’t
been inserted in to the product, a timed cycle will start
automatically.
It is necessary to wait 2 minutes after the end of the preparation
cycle for the automatic recognition (see section below).
C.2.2.3 How to select a “turbo cooling” cycle
To select the “turbo cooling” cycle, press the key ; the
LED will turn orange.
To start the cycle press the key .
C.2.2.4 Selecting a program:
First of all, the user has to decide what kind of cycle to launch
(SOFT, HARD, etc.) and then select the program.
Go through the following steps:
• Select the type of cycle;
• Press the program select button ; the program indicator
light lights up.
• press the select button until the chosen program
indicator light switches on.
• if the type of program is right, start it by pressing button .
if not
• keep pressing the select button until the chosen
C.2 USER INSTRUCTIONS