ProSoft Technology AN-X2-SQD - Manual (Page 19)

AN-X2-SQD-MAS Page 13
Default Gateway: 10.10.0.1
===========================================================================
Persistent Routes:
None
If there is no entry in the network destination column that starts with 169.254.0.0
(highlighted above), add a route using
route add 169.254.0.0 mask 255.255.0.0 10.10.0.20 metric 20
where 10.10.0.20 is replaced with the IP address of the interface in your computer that is
connected to the AN-X2.
IMPORTANT!
You may need to run this command as administrator
Repeat the route print command and confirm that the table now has an entry similar to the
one shown.
Now try pinging the AN-X2 at 169.254.42.84. You should now be able to access it using
a browser to set the desired Ethernet configuration.