ProSoft Technology AN-X-AMX - Manual (Page 15)

AN-X-DCSLOG Page 11
To configure the AN-X to obtain its IP address from a DHCP server on the network,
select Obtain an IP address automatically (DHCP)
To configure the AN-X to use a static IP address, select Use the following Settings and
enter:
• the desired IP address for the AN-X.
• the Subnet mask for the AN-X
• the default gateway for your network.
You must enter a valid default gateway address even if there is no device at the gateway
address on the network.
Click OK to complete the configuration.
If you Cancel the Configuration/AN-X IP Settings command, AN-X is left running the
boot code. Use the Utilities/Restart AN-X command to restart the AN-X.
Reconfiguring an AN-X from an Unknown State
It sometimes happens that an AN-X has been previously configured with an IP address
that causes it to be inaccessible on the current Ethernet network. To reconfigure it to a
known state, run the command Configuration/AN-X IP Settings to start the AN-X IP
Configuration Wizard and reconfigure AN-X.