PLANET ENW-9503A - Manual (Page 10)

3B
Chapter 4 Advance Feature
This chapter describes how to use the Wake-On-LAN feature to wake-up the LAN group PCs. Before
you using the feature, please check the note as below.
12B
4.1 How to enable the Wake-On-LAN Feature (ENW-9503A Only)
Before you use the Wake-On-LAN, here are some point have to note:
1. Check your Mother Board supports this feature.
2. If your Mother Board not supports the standard for PCI 2.2 above, you have
to use the WOL cable to connect with the Mother Board.
1. When the PC start, press “ Delete ” button to enter the BIOS management screen. Than select
the “Power Management Setup” item.
2.Enabled the “Wake-UP by PCI card” item.(Note: The Wake On LAN item on the different
maybe have the different name, as Wake Up on LAN , Automatic Power Up, Resume by LAN ,
Power Up On PCI Device, PME Event Wake Up…etc)
3. The other PC which in the same LAN group can via the Wake-On-LAN program to wake-up this
PC which installed the ENW-9503A.
7