PLANET CS-5800 - Manual (Page 10)

10
Step 2. Click Enable to active Remote Management. And then enter the control
port you want to use. The default value is 8080.
Step 3. Click Apply to save the configuration. And you can type the http://WAN
IP address: 8080 to access the router from the remote side.
Step 4. To verify the IP addresses of your computer and the security router.
Click Start form Windows  Run. Type the cmd to open the command
window, then type ipconfig for getting default gateway address. In the
below case, the default gateway is 192.168.1.1 and the user’s PC is
192.168.1.100.
Figure 3-8 Check the IP address for the PC and router
Note
If the default gateway is 0.0.0.0 or 169.x.x.x, it means the router
doesn’t obtain an IP address correctly. Please check your adapter
installation, security setting and the network connection first.