Mpman FRA202 - Manual (Page 7)

90 minutes ).
3) Press the SLEEP / SNOOZE (5) button repeatedly until the display shows the desired SLEEP time
period. The time period is shown on the display in sequence as 90 > 80 > 70 > 60 > 50 > 40 > 30
> 20 > 10 > 0 ( OFF ).
4) In 2 seconds after the desired SLEEP period is chosen, the display will change to show the radio
frequency, and then the current time. The radio will play for the SLEEP time duration you have
set and then be turned off automatically.
5) Press the SLEEP/SNOOZE (5) button again during SLEEP mode, the LED will show
the remaining time of the SLEEP period, and the SLEEP time can be set again
by pressing the SLEEP/SNOOZE (5) button.
6) To switch off the SLEEP function during the SLEEP mode, simply press ON/OFF button (1) once
and the radio will be turned off immediately.
SETTING THE SLEEP TIMER AND ALARM TOGETHER
1) If you want to set the SLEEP TIMER function and Alarm function together, you
must follow the ALARM SETTING procedure to set the alarm first.
2) Keep the radio turned off, then follow the step 2 & 3 of SETTING THE SLEEP
TIMER. Consequently, the radio will be turned on immediately, then turned off
automatically after the SLEEP time elapse, and then wake you up at your set
alarm time.
HIGH / LOW DIMMER FOR LED DISPLAY
One can adjust the brightness of the LED display to cope with requirement due to different
environment.
1) When the bedroom light is turned off, and you may feel the LED light of this unit is too bright. Just
press Dimmer button (2) once, the LED will show “L”, then it will switch to show the time in lower
brightness, so it will not disturb your sleep.
2) When you finish your sleep, and turn on the bedroom light, you may find the LED
of this unit is too dim to be seen. Just press Dimmer button (2) once again, the
LED will show “H”, then it will switch to show the time in higher brightness, so you can see the time
more clearly.