Mpman FRA202 - Manual (Page 5)

TIME SETTING
1. When the unit is first plugged into the AC mains, “0:00” will appear with the 1
st
0 digit flashing,
indicating that the HOUR is ready to be set.
2. Press – button (8) or + button (9) repeatedly to choose the correct HOUR.
3. After correct HOUR is set, press TIME SET button (2) once, then the minute digits will flash,
indicating the MINUTE is ready to be set.
4. Press – button (8) or + button (9) repeatedly to choose the correct MINUTE.
5. After setting to the correct time, either press TIME SET button (2) once, or just leave 5 seconds,
then the display stop flashing, and the clock will start run from the set time.
6. To change the current time, switch off the radio. Press and hold TIME SET button (2) for 2
seconds until the display flashes, then follow the same steps as point 2, 3, 4 & 5 above to set the
new time.
DUAL ALARM FUNCTION
This product allows the user to set to dual alarm function. Each alarm function can be set
independently, either wake to radio, or wake to buzzer. When any one of the set alarm is wake to
radio, please be reminded to select the desired band, station and volume level before turning off the
radio.
ALARM SETTING
1. To set the alarm time, the radio must be turned off.
2. Press ALARM 1 button (6) for 2 seconds, the HOUR digits will flash, indicating that alarm time of
Alarm 1 is ready to be set with either ALARM 1 Buzzer indicator (14) or Alarm 1 Radio indicator (15)
is turned on.
3. Press – button (8) or + button (9) repeatedly to choose the correct HOUR.
4. After the correct HOUR of Alarm 1 is set, press ALARM 1 button (6) once, the MINUTE digits will
flash.
5. Press – button (8) or + button (9) repeatedly to choose the correct MINUTE.
6. After setting the desired alarm time, either press ALARM 1 button (6) again,
or simply wait for 5 seconds, then the display will return to the current time
and the set alarm time is confirmed.
7. Now press ALARM 1 button (6) repeatedly to choose the alarm function status.
The status appears in following sequence with display shown as :
A) Alarm wake to buzzer is set with Alarm 1 Buzzer indicator (14) is ON and Alarm time is shown
on the display.
B) Alarm wake to radio is set with Alarm 1 Radio indicator (15) is ON and Alarm time is shown on
the display.
C) Alarm off is set with no indicator is on and Alarm time is shown on the display
5 seconds after the desired status is chosen, the display will change to show the current time.