EchoStar 44 User Manual
EchoStar Satellite
Table of contents
Document Outline
- DISH Pro Plus 44 Multi-Dish Switch
- Installation Guide
- Important Safety Instructions
- Contents
- Introduction
- Features
- Installation Instructions
- Figure 1. Mounting the Switch
- 2. Connect the coaxial cables from the LNBFs in your system to the ports on the switch labeled To Dish (see also the wiring diagrams that begin on page 17).
- 3. Connect a cable between To Power Inserter 1 connection on the switch and the power inserter marked To Switch Input 1.
- 4. Connect the cables from the receiver’s back panel Satellite In port(s) to the To Receiver Satellite In port of the power inserter installed in the previous step, or to switch ports Ç through Ñ labeled To Receiver Satellite In.
- a. Connect a cable from a To Receiver Satellite In port on either the switch or power inserter to the DISH Pro Plus Separator.
- b. Connect cables between the receiver Satellite In 1 and Satellite In 2 to ports 1 and 2 respectively on the DISH Pro Plus Separator.
- 4. Make sure all connections are secure.
- 5. Plug the power supply for the power inserter into a power outlet.
- Run Check Switch
- Figure 2. Point Dish Screen
- Figure 3. DISH Pro Plus Installation Summary
- Figure 4. Non-DISH Pro Installation Summary
- Figure 5. Non-DISH Pro Installation Summary
- Figure 6. DISH Pro Plus 44 Connections
- Figure 7. Additional DISH Pro Plus 44 Switches