Run check switch, Figure 2. point dish screen – EchoStar 44 User Manual
Page 11
12
Run Check Switch
After you have connected your switch to the LNBFs and
receivers in the system, you will need to run Check Switch
on each receiver in your system, one at a time. Follow these
instructions for each receiver:
1. Open the Point Dish/Signal Strength screen. See
your DISH Network satellite receiver user’s guide for
instructions. A Point Dish/Signal screen similar to the
one shown as Figure 2 will open.
Note: Models 2800, 3900, 4900, and 6000 must select
SuperDISH/129 to see the fourth port.
Figure 2. Point Dish Screen