DE DIETRICH DOS1160 - Manual (Page 28)

28
3 / TROUBLESHOOTING PROBLEMS EN
Tip
In all cases, if you cannot solve the problem yourself, call the after-sales department.
Although you may be unsure that your oven is operating correctly, this does not
necessarily mean that there is a problem with it.
In all cases, check the following points:
Attention
Repairs to the appliance should only be done by a qualified professional. Repairs not carried
out correctly could be a source of danger to the user.
YOU NOTICE
THAT...
POSSIBLE
CAUSES
WHAT TO DO
Your oven does not get
hot.
- The oven is not connected.
- The fuse in your installation
has blown.
- The selected temperature is
too low.
➡ Connect your oven.
➡ Change the fuse in your
installation and check its value (16A).
➡ Increase the selected
temperature.
The padlock flashes.
- Door locking fault.
➡ Call the after-sales department.
The lamp in your oven
no longer works.
- The lamp has blown.
- Your oven is not connected
or the fuse has blown.
➡ Call the after-sales department.
➡ Connect your oven or change the
fuse..
Pyrolysis fails to
operate.
- The door is not closed
properly.
- The locking system is
defective.
➡ Check the door closing
mechanism.
➡ Call the after-sales department.
Your oven emits beeps.
- During cooking.
- At the end of cooking.
➡ The temperature you chose has
been reached.
➡ Your cooking programme is
complete.
The cooling fan
continues to run when
the oven stops.
- Ventilation continues for a
maximum of one hour after
cooking or when the oven
temperature is greater than
125°C.
- If it does not stop after one
hour.
➡ Open the door to accelerate the
oven cooling.
➡ Call the after-sales department.
There is water in the
bottom of the oven.
- The boiler is suffering from
excessive scale.
➡ Hold the
button pressed and
follow the procedure
on p.11.