Electrolux 16850A - Manual (Page 8)

The programme progress display shows the washing or drying phases of the selected
programme. During a cycle, a black line blinks under the phase symbol of the running
programme. At the end of each phase, the line under the corresponding symbol becomes
fixed.
If the OVERDOSAGE symbol lights up at the end of the programme, it indicates that too
much detergent has been used.
9.4 - DOOR - symbol (Door locked)
• This symbol indicates if the door can be opened:
– the symbol is on: the door cannot be opened. The appliance is performing a wash-
ing or drying programme.
– the symbol is off: the door can be opened. The washing programme or drying is fin-
ished.
9.5 - Options: PREWASH , STAIN , SENSITIVE , DAILY , SUPER QUICK -
symbols
9.6 - CHILD SAFETY LOCK - symbol
9.7 - The display shows the following information:
• Duration of the selected programme
After selecting a programme, the duration is displayed in hours and minutes (for ex-
ample ) . The duration is calculated automatically on the basis of the maximum
recommended load for each type of fabric. After the programme has started, the time
remaining is updated every minute.
• Delay start
The selected delay (20 hours max) set by pressing the relevant button appears on the
display for a few seconds (for example ), then the duration of the previously se-
lected programme is displayed.
The DELAY START symbol will appear on the display. The delay time value decreases by
one unit every hour and then, when 1 hour remains, the time decreases every minute.
• Selected drying time
After selecting a drying programme, the drying time is displayed in minutes and/or
hours (max 250 mins).
After the programme has started , the time remaining id updated every minutes.
• Incorrect option selection
If an option, which is not compatible with the set wash programme is selected, the
message Err is displayed for a few seconds and the yellow light of button 7 starts
blinking.
• Alarm codes
In the event of operating problems, some alarm codes can be displayed, for example
(see chapter «What to do if...»).
• End of the programme
When the programme has finished a blinking zero is displayed, the DOOR symbol
disappears and the door can be opened.
9.8 - DRYING TIME duration - symbol
9.9 - DELAY START - symbol
8