Electrolux 16850A - Manual (Page 15)

• reduce the spin speed if needed, by pressing the relevant button
• press the button 7
• when the programme has finished the display shows a blinking . On the display the
DOOR symbol disappears. The door can now be opened.
Turn the programme selector dial to to switch the machine off. Remove the laundry
from the drum and carefully check that the drum is empty.
If you do not intend to carry out another wash, close the water tap. Leave the door open
to prevent the formation of mildew and unpleasant smells.
Stand by : once the programme has finished after a few minutes the energy saving sys-
tem will be enabled. The brightness of the display is reduced. By pressing any button the
appliance will come out of the energy saving status.
USE - DRYING
Drying only
The recommended load size is 3,5 kg for cottons and linen, and 2 kg for synthetic items.
By pressing Drying Time button it is also possible to dry up to 5 kg of cotton items (see
the «Drying Programme » table).
The water tap must be open and the drain hose must be positioned in the sink or
connected to the drain pipe.
1. Load the laundry.
2. Select a spin cycle at the maximum spin speed allowed for the type of laundry in
order to obtain the best drying performances.
3. Select the drying programme for Cottons or Synthetic in the Drying sector of the
programme selector dial. The DRYING and the ANTI-CREASE symbols corresponding
to the phases making up the programme appear on the display. At the same time,
the symbols corresponding to the level degrees allowed by the set programme/fabric
and «AUTO» lights up.
4. – Select the automatic drying by pressing the button 3 .
With this button you can select the degree of dryness by an electronic drying. The
machine adapts automatically the duration of the drying cycle to the selected de-
gree of dryness. If you press this button, a black dash appears under the selected
symbol to indicate that a degree has been set. The message «AUTO» disappears. The
display shows the duration of the drying cycle. The pilot light of button 7 starts
blinking. Press then button 7 to start the programme. A black dash flashes under
the DRYING symbol.
– Select the timed drying by pressing the button 4
With this button is possible to select the duration of the drying cycle from 10 to
250 minutes according to the type of fabric (cotton or synthetic). Press this but-
ton, until the time you want appears on the display. Every time you press this but-
ton the drying time increases by 5 minutes. The DRYING TIME DURATION symbol
appears for a few seconds on the display near the duration value. Press then but-
ton 7 to start the programme. A black dash flashes under the DRYING symbol.
Note!
15