Electrolux EW 1418 1 - Manual (Page 9)

9
After the machine has started, only the running phase
light illuminate and stay on.
When the programme has finished, the “End” pilot light
comes on.
The “End” pilot light flashes in the event of operating
problems and the corresponding alarm code appears on
the display..
EE1100 = the machine does not fill
EE2200 = the machine does not empty
EE4400 = the door has not been closed
To eliminate the problem, see paragraph “Something not
working”.
If the “Filter clogged” pilot light flashes at the end of
the programme this means that the drain filter must be
cleaned.
14 Programme selector dial
The selector is divided into the following sections:
• Cotton,
• Synthetics
• Delicates
• Wool
• Handwash
• Special programmes
• Reset programme Off
The selector dial can be turned either clockwise or
anticlockwise.
60°
40°
40°-
Off 95° Delicate Spin
Spin
Drain
Rinses
Handwash
Cotton
Synthetics
Delicates
E40°
30°
30° 40°-60°Mix
30°
E60°
60°
60°
40°
30°
40°
Rinses
Prewash
Wash
Spin
Rinse Hold
Drain
Filter Clogged
End
Positions E60°, E40° and 40°-60°Mix correspond to the
ENERGY SAVING programmes and position
to
“cold wash”.
At the end of the programme the selector dial must
be turned to position “Off” (reset).
Functions
End of programme
When the “End” pilot light on the programme progress
display illuminates, the door can be opened (if the Rinse
hold
or Night Cycle option has not been selected).
Turn the programme selector dial to Off.
Switch the machine off by depressing the ON/OFF
button before removing the laundry.
Altering an option or a running programme
It is possible to change any option before the
programme carries it out.
Before you make any change, you must pause the
washing machine by pressing the START PAUSE
button.
Changing a running programme is possible only by
resetting it. Turn the programme selector dial to "Off"
and then to the new programme position.
Start the new programme by depressing the START
PAUSE button. The washing water in the tub will not
emptied out.
Interrupting a programme
Depress the START PAUSE button to interrupt a
programme which is running: the corresponding light
starts to flash.
Depress the same button to restart the programme.
Opening the door after the programme has
started
You can open the door, after having set the washing
machine to PAUSE, provided the following conditions
exist:
• the washing machine has not heated beyond 55°C;
• the level of the water is not high;
• the drum is not turning.
If these requirements are met, when you pause the
washing machine, the door can be opened.
13294920.qxd 30/11/2005 11:22 Pagina 9 (Nero/Process Black pellicola)