SAF-HOLLAND XL-LG315-01 Formula 150 Landing Gear (Manufactured after March 1, 2000) - Manual

LANDING
GEAR
Do not deviate from these instructions. Any changes or
deviations will void all warranties, expressed or implied,
unless written consent is first obtained from the factory.
OPERATION OF HOLLAND
FORMULA 150 LANDING GEAR:
NOTE: Holland Formula 150 2-speed gearbox has high
and low range gears. High range gear is to be used only
for rapid traverse up from and down to the ground and is
not intended to lift or lower any load. For additional infor-
mation, see Holland publication XL-FW302-XX, entitled
"Fifth Wheel Operating Instructions."
TO EXTEND:
On outside mounted landing gear, engage the crank with
the crankshaft and turn the crank clockwise. Inside mounted
landing gear are extended by turning the crank counter-
clockwise. Using high gear, lower the landing gear until the
pads make contact with the ground. To reduce the load on
the fifth wheel, shift to low gear and crank an additional
four to eight turns. Leave the landing gear in low gear and
store the crank handle in the holder provided.
TO RETRACT:
On outside mounted landing gear, engage crank with
crankshaft and turn the crank counterclockwise. Inside
mounted landing gear are retracted by turning the crank
clockwise. Retract the landing gear using low gear until
unloaded. Then shift to high gear and continue cranking
until fully retracted. Leave the crankshaft engaged to
prevent road vibration wind-down. Store the crank in the
holder provided.
XL-LG315-01 1
CAUTION
• Always grip crank handle securely.
• Always grip crank handle securely
with both hands before shifting.
• Never shift landing gear
under load.
• Never leave the crank unsecured.
• Never raise or lower a loaded
trailer in high gear.
Formula 150 Landing Gear
(Manufactured after March 1, 2000)
OPERATING, MAINTENANCE,
AND REPAIR PROCEDURES
RETRACT
TRAILER
COUNTER CLOCKWISE
HIGH
CLOCKWISE
EXTEND
LOW
Before operating, identify the mounting style of your land-
ing gear — inside or outside mount (see figures below).
• Push crank handle in for low speed.
• Pull crank handle out for high speed.
• Turn crank:
Counterclockwise = extend
Clockwise = retract
TRAILER
COUNTER CLOCKWISE
LOW
CLOCKWISE
HIGH
RETRACT
EXTEND
• Push crank handle in for high speed.
• Pull crank handle out for low speed.
• Turn crank:
Counterclockwise = retract
Clockwise = extend
OUTSIDE MOUNT
INSIDE MOUNT