Emerson KF240PRZ00 - Manual (Page 12)

12
7. Screw in three 40-watt (maximum)
candelabra bulbs in the light fitter
sockets (Figure 17). Carefully place the
lower glass over the light fitter threaded
nipple. Be sure the glass is firmly
seated on the fitter, then secure in
place using a rubber washer, metal
washer, and 1/8-27 nut (washers and
nut are supplied).
8. Place the decorative cap over the
threaded nipple and then screw on the
finial nut (Figure 17).
9. Your ceiling fan is now installed and
wired to be controlled by your fan/light
wall control.
To avoid possible fire or shock, make
sure that the electrical wires are
completely inside the outlet box and
not pinched between the ceiling
cover and the ceiling.
! WARNING
SW101 FAN/LIGHT WALL
CONTROL (SUPPLIED)
BLACK
BLACK
WHITE
RED
BLACK
WHITE
HANGER BALL
GREEN WIRE (GROUND)
FROM HANGER BALL AND
HANGER BRACKET
TWO-CONDUCTOR
CABLE (WITH
GROUND)
BLACK
(HOT)
WHITE
GROUND
TO
120-
VOLT
SUPPLY
WHITE
BLUE
WHITE BLUE
EMERSON ®
HI
MED
LOW
FAN OFF
LIGHT
ON OFF
Figure 15
3. Push the wires and connectors up into
the outlet box while inserting the
receiver fully into the hanger bracket.
Position the antenna wire on top of the
receiver.
4. Screw the two 1-1/4” threaded studs
(supplied) into the tapped holes in the
hanger bracket (Figure 14).
5. Lift the ceiling cover up to the threaded
studs and turn until the studs protrude
through the holes in the ceiling cover
(Figure 16).
6. Secure the ceiling cover in place by
sliding lockwashers (supplied) over the
threaded studs and installing the two
knurled knobs (supplied). (Figure 16).
Tighten the knurled knobs securely
until the ceiling cover fits snugly against
the ceiling.
CEILING COVER
LOCKWASHER (2)
KNURLED
KNOB (2)
1-1/4" THREADED
STUD (2)
Figure 16
BP7308 LORRAINE KF240 2/15/06 3:21 PM Page 12