Fulton Performance 1413230134 - Manual

Before mounting the jack confirm that there will be no interference from the tow vehicle, tongue, ground, and any other mounted accessories while
stationary or in motion. Before installing, check for interference in all positions including handle swing and swivel positions. Check for interference
again after installation is complete. The height of the swivel mount is pre-set and torqued by the factory at a common height for most applications.
Read, Understand, Follow and Save These Instructions
• This product must be installed and used in strict
accordance with these instructions. Purchaser/
owner must not alter or modify the product.
• Operator and bystanders should never position
any part of body under or on the path of any
portion of this product or the load being
supported, or moved.
• Fully retract and rotate jack into its stowed
position before towing.
• This product is not intended to be used as a
transport device for the implement it is attached
to. Minimize movement of implement while jack
is under load.
• Do not allow children to play on or around this
product or the load being supported, or moved.
• Secure the load, vehicle and trailer from rolling
(by blocking wheels) when operating jack or
coupling trailer.
• Never exceed maximum rated capacity. Refer to
stamped markings or decals on product to obtain
rated capacity. If uncertain, contact Cequent
Trailer Products at 800-604-9466 or
www.cequentgroup.com.
• These jacks are designed for vertical loading.
Excessive side forces may cause jack failure and
must be avoided.
• Before manually moving trailer, crank to lowest
position.
• Lock the plunger pin into a hole in the mounting
bracket before raising or lowering the tongue.
• These jacks are not designed for mounting to
round tongues.
• Do not cut, drill, weld or modify this jack in any
manner not described in these instructions.
• All welding must be performed by an AWS
certified welder.
• Always replace bent, broken, or worn parts before
using this product.
Read, understand and follow all of these instructions and warnings (Instructions) before installing and using this product. Install and use this product only as
specified in these instructions. Improper installation or use of this product may result in property damage, serious injury, and/or death. Never allow installation
or use of this product by anyone without providing them with these instructions. You must read, understand and follow all instructions and warnings for any
product(s) to which this product is used in conjunction with or installed. Save these instructions with the product for use as a reference for any future
installation and use of the product.
Failure to follow all warnings and instructions may result in product
failure, property damage, serious bodily injury, and/or death. WARNING
Installation Instructions Warning: Failure to follow all warnings and instructions may result in
product failure, property damage, serious bodily injury, and/or death.
Trailer Jack
F3576 (Rev-D 17805) 08/12
Mounting Plate
3/8-16 x 7/8 Lg bolt
Lock Washer
XXXXXXXXXXXXXX
XXXXXXXXXX
Weld-on:
Mounting Plate is included on Weld-On
models only.
All welding must be performed by an AWS
certified welder. Recheck the position of
the mounting plate according to the
precautions listed above and as shown in
diagram below. Position the plate with the
flat surface toward trailer. Align top of
mounting plate flush with top of trailer tube
and weld completely around using a 3/16”
fillet weld. The threaded holes in the
mounting plate may need to be masked for
painting or re-tapped, depending on trailer
finish requirements.
Adjusting Swivel Mount Height: (if necessary)
With jack removed from trailer, loosen the two swivel fasteners until the slide block moves freely along outer tube.
To access the upper bolt, be sure the swivel bracket is rotated in the horizontal (3” mounting) position as shown.
Adjust swivel mount to desired location and re-torque to 60-70 ft-lbs. After adjustment, check for proper swivel and
pin engagement.
U.S. Patent # D568575, D570072, D577175 and Patents Pending