TOPICA TP-S1016DR - Manual (Page 24)

MENU
6.8 RECORD SETTING MENU
RECORD SETTING MENU
NORMAL RECORD
SPEED
QUALITY
DISK FULL
: 50 IPS
: STANDARD
: REWRITE
ALARM RECORD
OPERATION
SPEED
QUALITY
ON
: 50 IPS
: STANDARD
PRE-ALARM RECORD
OPERATION ON
In NORMAL RECORDING MENU, we define
(1) NORMAL RECORD:
SPEED : To set the normal recording speed. Maximum 60 (NTSC) / 50 (PAL).
QUALITY: Video recording quality setup for setting the quality of the video picture by
selecting a compression rate. There are six quality levels for recording
LOWER : 15 KB
LOW : 19 KB
BASIC : 23 KB
STANDARD : 27 KB
HIGH : 31 KB
SUPERIOR : 35 KB
DISK FULL: Set REWRITE or STOP when HDD is full.
(2) ALARM RECORD (for Alarm In and Motion detection):
OP (Operation): Select ON or OFF to activate alarm recording or not.
SPEED : To set the alarm and motion recording speed. Maximum 60 (NTSC) / 50
(PAL).
QUALITY: Video recording quality setup, this item lets you set the quality of the video
picture by selecting a compression rate.
NOTE: The record rates are for the total system: The single camera record rate is:
Camera record rate = System record rate / Number of connected cameras
Example: Record Rate 60 IPS, 6 connected cameras: 10 IPS / camera
(3) PRE-ALARM RECORD: (with Alarm In and Motion)
Pre – Alarm duration is depending on record quality (about 8-15 seconds).
OP (Operation): Select ON or OFF to activate pre-alarm recording or not .
Turn the JOG dial clockwise or counter-clockwise to select the options.
Press MENU key to return to Main Menu, press again to leave Set up Menu.
MENU
Press ENTER key to confirm the option and move to next column.
ENTER
19