Everpure H-300-HSD - Manual (Page 2)

product specifications
Health Claim Performance by NSF/ANSI*
This system has been tested according to NSF/ANSI 42 and 53 for the reduction of the substances listed below. The concentration of the
indicated substances in water entering the system was reduced to a concentration less than or equal to the permissible limit for water leaving
the system, as specified in NSF/ANSI 42 and 53.
Influent Challenge Max. Permissible Product Reduction Minimum Average
Substance Concentration Water Concentration Requirements Reduction Reduction
Standard 42-
Aesthetic
Chlorine 2.0 mg ± 10% – >_ 50% – 96.8%
Particulate, Class I
Particles 0.5 - 1 µm
at least 10,000 particles/mL – >_ 85% – 99.2%
Standard 53-
Health
Asbestos 10 7 to 10 8 fibers/L > 10 micrometers in length 99% 99.86% 99.86%
Cyst Minimum 50,000/L – 99.95% 99.99% 99.99%
Lead 6.5 0.15 mg/L ± 10% 0.010 mg/L – 99.4% 98.8%
Lead 8.5 0.15 mg/L ± 10% 0.010 mg/L – 97.3% 98.7%
Chloroform 0.310 mg/L 0.015 mg/L – 95.7% 98.6%
(VOC surrogate chemical)
*Tested using flow rate=0.5gpm; pressure=60 psig; pH=7.5 ±0.5; temp.=20˚C ±2.5ºC
Everpure, Micro-Pure and the silver canister color are registered trademarks of Everpure, LLC © 2008 ® ®
Chemical Reduction
> Taste and Odor
> Chlorine Taste and Odor
Mechanical Filtration
> Particulate Reduction: Class I
Chemical Reduction
> VOC
Mechanical Filtration
> Cyst
> Asbestos
System Tested and Certified by NSF International against NSF/ANSI
Standard 42 and 53 for the reduction of:
Standard No. 42 Aesthetic Effect: Standard No. 53 Health Effects:
> Lead
H-300-HSD
Commercial grade drinking water system
for the home
This drinking water system must be
maintained according to the
manufacturer's instructions, including
replacement of filter cartridges. The
substances reduced or removed by this
system are not necessarily in your water.
Read the performance data sheet.
flow rate
Controlled at 0.5 gal./min. (1.9 L/min.)
temperature
35-100 °F (2-38 °C) cold water use only
pressure
10-125 psi. (0.7-8.6 bar), non-shock
capacity
300 gal. (1,135 L)
everpure warranty
Everpure Drinking Water Systems are
warranted to be free of defects for a full
twelve (12) months after purchase. A
detailed warranty statement is provided
with each system.
H-300-HSD System – Part No. EV9270-77
H-300-HSD Cartridge – Part No. EV9270-75
Features:
> For high silt density water vs. standard H-300.
> Finely polishes treated water to premium quality for drinking and cooking.
> Reduces chlorine taste and odor.
> Reduces dirt, rust, asbestos fibers, and other particulates such as oxidized iron, manganese, and
sulfides.
> Reduces parasitic protozoan cysts such as Giardia, Entamoeba, and Cryptosporidium.
> Controls even extreme levels of common “off” tastes and odors, including those which are earthy,
moldy, and fishy.
> Reduces lead to below the Federal Action Level.
> Effectively reduces Volatile Organic Chemicals (VOCs).
> KDF Media reduces limescale build-up in water-using appliances — as tested by KDF® Fluid
Treatment, Inc.
> KDF Media provides bacteriostatic control — as tested by KDF® Fluid Treatment, Inc.
General Installation/Operation/Maintenance Requirements
> It is recommended that before purchasing a water treatment unit, you have your water tested to
determine your actual treatment needs.
> Space required: 5 x 5 x 22 in. (13 x 13 x 56 cm) including 2-1/2 inches of clear space under unit for
cartridge change.
> Install vertically with cartridge hanging down.
> Replace cartridges when capacity is reached, or when flow becomes too slow, but at least annually.
> Do not use with water that is microbiologically unsafe or of unknown quality without adequate
disinfection before or after the system. Systems certified for cyst reduction may be used on
disinfected water that may contain filterable cysts.
> A separate drinking water faucet is required.