beautypg.com

Installing the cooker hood, Drilling the ceiling/support shelf, Fixing the frame – Electrolux CHI 950 User Manual

Page 14

background image

14

INSTALLING THE COOKER HOOD

Drilling the Ceiling/Support
Shelf

• Use a plumb line to mark the centre of the hob on

the ceiling/support shelf.

• Place

the

drilling

template

21 provided on the ceiling/

support shelf, making sure that the template is in the
correct position by lining up the axes of the template
with those of the hob.

• Mark the centres of the holes in the template.
• Drill the holes at the points marked:

• For concrete ceilings, drill for plugs appropriate to

the screw size.

• For hollow brick ceilings with wall thickness of 20

mm: drill ø 10 mm (immediately insert the Dowels
not provided).

• For wooden beam ceilings, drill according to the

wood screws used.

• For wooden shelf, drill ø 7 mm.
• For the power supply cable feed, drill ø 10 mm.
• For the air outlet (Ducted Version), drill according

to the diameter of the external air exhaust duct
connection.

• Insert two screws of the following type, crossing them

and leaving 4-5 mm from the ceiling:
• For concrete ceilings, use the appropriate plugs

for the screw size (not provided).

• For Cavity ceiling with inner space, with wall thi-

ckness of approx. 20 mm, Screws not provided.

• For wooden beam ceilings, use 4 wood screws

(not provided).

• For wooden shelf, use 4 screws with washers and

nuts (not provided)

Fixing the Frame

• Loosen the two screws fastening the lower chimney

and remove this from the lower fra me.

• Loosen the two screws fastening the upper chimney

and remove this from the upper fra me.

If you wish to adjust the height of the frame, proceed
as follows:

• Unfasten the eight metric screws joining the two

columns, located at the sides of the frame.

• Adjust the frame to the height required, then replace

all the screws removed as above.

• Insert the upper chimney stack from above, and leave

it running free on the frame.

• Lift up the frame, fi t the frame slots onto the screws

up to the slot end positions.

• Tighten the two screws and fasten the other two

screws provided with the hood.

2

2

1

1