SAF OPAL Pro DeviceNet - Manual (Page 10)

Opal Pro to DeviceNet
Page 10
Output Words
(Polled) Name Description
Word 1 Status Bit 0 – Ready to Run (drive is enable
and has 3 phase power)
Bit 1
–Running (start is regulating)
Bit 2 – Full On (starter is phased fully
on)
Bit 3
– Up to Speed (started is phased
fully on and the current is below 105%
of nameplate current as set in 13.01)
Bit 4
– Reverse
Bit 5
– Jogging
Bit 6 – DC Injecting
Bit 7 – Faulted
Bit 8
– IOC Fault
Bit 9
– MOL Fault
Bit 10 – Phase Loss Fault
Bit 11 – Shear Pin Fault
Bit 12
– Shorted SCR Fault
Bit 13
– Heat Sink OT Fault
Bit 14 – Reserved
Bit 15 – Watch Dog Bit
Word 2 Current Feedback 833 = 500% of motor name plate
current as set in 13.01
Word 3 Phase Angle
Actual Amount of time phased on in
microseconds
Word 4 Current Current feedback in Amps
Word 5 L1 to L2 Voltage Line 1 to Line 2 Voltage in Volts
Word 6 L1 to L3 Voltage Line 1 to Line 3 Voltage in Volts
Word 7 L2 to L3 Voltage Line 2 to Line 3 Voltage in Volts
Word 8 DI Status Digital input status
Bit 0
– Start
Bit 1
– Stop
Bit 2 – Jog
Bit 3 – Reverse
Bit 4
– Reset
Word 9 Analog Input Analog input value in Volts X 100
Word 10 Relay Status Status of the Relay Outputs
Bit 0 – Running
Bit 1
– By-Pass
Bit 2
– Shorted SCR
Bit 3 – Reverse
Bit 4 – Faulted
Word 11 Analog Output Analog Output value in Volts X 100