Rose Electronics UltraVista LC II - Manual (Page 14)

INSTALLATION
UltraVista LC II HDMI Installation and Operations Manual 8
UltraVista LC II HDMI Installation
Installation of the UltraVista LC II HDMI is an easy process, and consists of
the following:

Install the display panels

Mount, if necessary, the video wall controller

Connect HDMI cables, video input cable and power adapter to the
video wall controller

Adjust the screen resolution output settings

Select a screen mode to display output

Adjust the video wall mask settings to align images
The unit can be set up to display three modes. The 1x1, or clone mode,
displays the full image on each output monitor. The 2x1, or replication
mode, displays the input image across each row of monitors. The 2x2, or
video wall mode, displays the input image across all monitors. Additionally,
while in 2x2 mode, it is possible to simulate a Picture In Picture (PIP) look
by having a complete image of the source in one of the four quadrants.
1 x 1 2 x 1 2 x 2
Clone Mode Replication Mode Video Wall Mode
These modes, including PIP, are selected by using the buttons on the front
of the unit, or by using the remote IR remote controller.