Rose Electronics Vista Remote 2 - Manual (Page 34)

28 Vista Remote 2 Installation and Operations Manual
Configure security
Figure 20. Switch module security settings
Configuration password:
Assigning a “Configuration password” prevents unauthorized changes to the Vista Remote 2
switches’ configuration. To change the password, highlight the configuration password field
and press to clear the existing password. Type in a new password (8 characters max /
case sensitive) and press . An input box will then appear requesting confirmation of the
password. Re-type the password and press .
You will be prompted for a password whenever you access the configuration menu (
F12).
Access password:
Assigning an “Access password” prevents unauthorized access to the connected computers.
To change the password, highlight the access password field and press to clear the
existing password. Type in a new password (8 characters maximum / case sensitive) and
press . An input box will appear for you to confirm the access password. Re-type the
same password and press . You will be prompted for an access password whenever
the Vista Remote 2 switch is powered on or you have disconnected from a computer.
To remove a password, highlight the configure password or access password field and press
enter to clear the password field. Press enter again with no password input and the password
will be removed. The configuration password must be entered before passwords can be
changed or removed.
DO NOT forget your configuration or access passwords.