RISCO Group Vitron WL Glass Break Detector User Manual

Page 2

5INT6G

11. Ordering Information

Part Number

Description

RWT6G086800A

868.65MHz

RWT6G043300A 433.92MHz

Note

: The detector contains a swivel

FCC Note

This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15
of the FCC Rules.
These limits are designed to provide reasonable protection
against harmful interference in a residential installation.
This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is
no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment on and off, the user
is encouraged to try to correct the interference by one or
more of the following measures:
Ê

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and

the receiver.

Connect the equipment into an outlet on to a different

circuit from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV

technician for help.

Changes or modifications to this equipment which are not

expressly approved by the party responsible for

compliance (RISCO Group's.) could void the user's

authority to operate the equipment.

FCC ID: JE4RWT6G Valid for P/N

GT74023

IC: 6564-RWT6G Valid for P/N

GT74023

10. Technical Specifications

Electrical
Current consumption
(standby)

22 uA at 3 VDC, without
acoustic signal
10 mA at 3 VDC
(Max. with LED OFF)

Current consumption
(Alarm transmission)

15 mA at 3 VDC
(Max. with LED ON)

Modulation type

ASK

Battery life

3 years, at 65 minutes
supervision

Supervision
transmission

Every 15/65 minutes.

Address codes

16 Millions

Range (loss)

300m (1000 feet)

Voltage
requirements

CR123A 3VDC Lithium
Batteries

Frequency GT74023

868.65MHz

Physical
Size
(LxWxD)

87 x 50.7 x 28.6 mm
(3.4 x 2.0 x 1.1 in.)

Environmental
Operating/Storage
temperature

0°C to 50°C (-32°F to 122°F)

RF immunity

20V/m (80MHz to 2GHz)

* Specifications are subject to change without prior
notice

Step 3: Environmental Test

This test is performed to verify interference produced
by environmental conditions or facilities.

To perform the test, operate all devices in the
protected region that may interfere with the detector,
including air conditioners, fans, radios etc.

Observe the wireless VITRON and note any
disturbances. If disturbances occur, re - positions the
unit in a different position and re- test.

Turn all noise generating equipment off and wait until
unit returns to NORMAL mode.

Note:

The Wireless VITRON will return to NORMAL mode
after two minutes. Setting the "CODE" switch and
pressing the "Manual" button at any time will initiate
another two minutes Test Mode.

Step 4: User test

The Wireless

VITRON can be tested by the installer or

the user while in normal mode by clapping or whistling
or key- jingling under the detector. The led will flash. No
report will be established.

9. Jumpers settings

Description

Jumper

position

J3 Power

High/Low

Low

power