Exmark TT4817KAC - Manual (Page 11)

- 6 -
1.4.17 Be aware of the mower discharge direction and do not point it at anyone.
1.4.18 Do NOT operate the mower under the influence of alcohol or drugs.
1.4.19 Use care when approaching blind corners, shrubs, trees, or other objects that may
obscure vision.
1.4.20 If jump starting is required: (Electric start units only)
a) connect the positive (+) power cable from the positive post on the booster
battery to the positive terminal post on the starter solenoid switch (this post
has the positive battery cable attached to it).
b) connect the negative or ground cable (-) from the negative post on the
booster battery to the engine block as far away from the battery as possible.
c) disconnect battery cables in the reverse order after starting.
1.5 MAINTENANCE AND STORAGE
1.5.1 For engine maintenance, follow the engine manufacture’s recommendations
precisely as stated in the engine manual.
1.5.2 Disconnect the battery from the negative battery post when the unit will be allowed
to sit for more than 30 days without use.
1.5.3 Allowing batteries to stand for an extended period of time without recharging
them will result in reduced performance and service life. To preserve optimum
battery performance and life, recharge batteries in storage when the open circuit
voltage drops to 12.4 volts.
Note: To prevent damage due to freezing, battery should be fully charged before
putting away for winter storage.
1.5.4 Keep engine and engine area free from accumulation of grass, leaves, excessive
grease, or oil and other debris, which can accumulate in these areas. These
materials can become combustible and may result in a fire.
1.5.5 Store fuel in a container specifically designed for this purpose in a cool, dry place.
1.5.6 Keep the mower and fuel container in locked storage to prevent children from
playing or tampering with them.
1.5.7 Gasoline powered equipment or fuel containers should not be stored in a
basement or any enclosed area, where open pilot lights or heat appliances are
present.
1.5.8 Maximum mowing results and safety can only be achieved if the mower is properly
maintained and operated correctly.
1.5.9 Check all bolts frequently to maintain proper tightness.
1.5.10 Keep all guards, shields, and all safety devices in place and in safe working
condition.
1.5.11 Frequently check for worn or deteriorating components that could create a hazard.
1.5.12 All replacement parts must be the same as or equivalent to the parts supplied as
original equipment.