Precision Medical PM15 EasyAir Compressor - Manual (Page 7)

6
GROUNDING INSTRUCTIONS
The Easy Air Compressor must be plugged into an electrical outlet that is
properly grounded. In the event of an electrical short circuit, grounding reduces
the risk of electrical shock. This product is equipped with a grounding circuit.
DANGER
Improper use of the grounding plug can result in a risk of electrical
shock.
WARNING
Ground reliability can only be achieved when the power cord is
connected to an equivalent receptacle marked “Hospital Grade”.
OPERATING INSTRUCTIONS
CAUTION
Inspect the Easy Air Compressor for visible damage, DO NOT USE
if damaged.
1. Become familiar with the Compressor (see Component Identification).
2. Position the Compressor near a properly grounded electrical
receptacle. Allow a minimum of 4 in (10 cm) clearance on all sides to
ensure adequate air flow for cooling of the Compressor.
3. Ensure the On/Off (I/O) Switch is in the “OFF” (O) position.
4. Ensure the Power Cord is properly connected.
5. Attach appropriate device to the Outlet Fitting securely, without
overtightening.
6. Pull Regulator Knob “OUT” to unlock regulator, then turn Knob
fully counterclockwise. (Failure to do so may cause the device
not to start.)
7. Press the On/Off (I/O) Switch to the “ON” (I) position.
8. Adjust pressure/flow.
To
INCREASE pressure / flow - Turn Knob CLOCKWISE
To DECREASE pressure / flow - Turn Knob COUNTERCLOCKWISE
9. Push Regulator Knob “IN” to lock pressure / flow setting.
10. Compressor is now ready to use.
11. When the Compressor is not in use, press the On/Off (I/O) Switch to
the “OFF” (O) position.