Meliconi Gumbody Universal 6 Light User Manual

Page 2

To programme the

U N I V E R S A L 6 L i g h t

remote control,

follow the indications in paragraph

The quickest and easiest way to programme the remote control is by

consulting the website

www.gumbodylight.com

Warning:

programme one appliance at a time!

BRAND SEARCH PROGRAMMING MODE

F I T T I N G T H E B A T T E R I E S

Before programming and using

the remote control, fit the batteries.

The remote control requires 2 new AA/LR06 batteries. Insert the batteries as shown:

• Change the batteries if the light indicator starts to flash

during use. The batteries are low.

• Make a note of the codes for your appliances on the

adhesive label inside the battery cover in case you have
to reprogramme your remote control.

• This remote control has a permanent memory and does

not lose the programmed codes or functions when the
batteries are removed.

To display and make a note of the code memorized by means of the search,

follow the instructions described in the paragraph CURRENT CODE DISPLAY.

ADDITIONAL CHECK

Check that some of the other functions used on your original remote control are working correctly. If the
commands function incorrectly or erratically, you have probably entered a code for a similar remote control
but not the right one. In this case, repeat the search procedure starting from point 3, entering the code
previously used (e.g. 0025).

1. Turn on the appliance to be programmed:

- if a VCR, insert a cassette
- if a SAT or TER select a programme
- if a DVD insert a DVD.

2. Look for the brand of the appliance you want to programme

in the code book and make a note of the code indicated
alongside (

e.g. PHILIPS 0025) or the code for the brand

indicated by the arrow.

3. Hold down the selection key for the appliance to be

programmed for 5 seconds.

4. When the key is released, it will start to flash. Enter the

brand code previously identified (

e.g. 0025). The selection

key flashes more quickly to indicate that the remote
control is ready for the search.

5. Point the remote control at the appliance. Press and slowly

release the ON/OFF key or PLAY for the VCR and DVD
several times, stopping when the appliance responds
correctly to the command.

6. When the appliance responds correctly, press OK to

confirm. Three flashes indicate that the search operation
has been completed correctly.

PHILIPS

0025

PHONOLA

PHILIPS

5 SEC.