Meliconi Speedy 210 combo User Manual

Page 5

Check that the other buttons correspond to the functions of the original remote control; if not, it is likely that the code

found is incorrect, but is used for a very similar device, therefore repeat the procedure from point

NOTE: During the search the indicator stops fl ashing and the remote control exits the programming mode in

the following cases:

• if for 12 seconds the button indicated is not pressed or if another button is pressed

• if the list of codes to fi nd is terminated. If this happens, go to the www.meliconi.com website

To go to the programming mode, according to requirements, use one of the following pairs of buttons:

VOL + and VOL -

to set the code for the TV part only - (light blue buttons)

P + and P -

to set the code for the DECODER part only - (dark blue buttons)

VOL + and P +

to set a single code and control only one device - (whole keypad)

Three long fl ashes indicate a correct setting. If they do not appear, repeat the procedure.

ENTERING THE CODE DIRECTLY

(only to be performed if you know the specifi c code to be set)

1. Switch to the programming mode by simultaneously

holding down the appropriate pair of buttons.

2. When the indicator light starts fl ashing, release the

buttons and immediately enter the specifi c code

previously found.(e.g.: 1306)

Example of TV code

If you set up the remote control using the

MANUAL SEARCH procedure, obtain and make a note of the code in use

as follows:

DISPLAY CODE IN USE

1. Simultaneously hold down the VOL+ and VOL- buttons (if

you want to fi nd the codes of analogue or digital TVs), or

P+ and P- (to fi nd the decoder code).

2. When the indicator light starts fl ashing, release the

buttons and briefl y press the

TV/RADIO button.

3. After a pause of several seconds, the indicator light

produces four sets of fl ashes, spaced out, corresponding

to the code to be obtained. Count the number of fl ashes.

Each set of fl ashes corresponds to one fi gure in the code.

Ten fl ashes correspond to the fi gure 0. For example, for

the code 1306 the following fl ashes will be obtained:

TV Code

Decoder Code

Make a note of the code obtained on the label on the inside of the battery cover. You may need it in future.

Code obtained =

1306

This manual is related to the following products: