Meliconi Speedy 210 combo - Manual (Page 3)

9
MANUAL CODE SEARCH
(only to be performed if the specifi c code could not be found)
IMPORTANT - separate the information with a comma, and be as precise as possible so that the IT system can
search the data and respond correctly.
Send the SMS to the number 0039 345 7518893 and wait for an SMS reply.
Once you have received the SMS with the list of codes, set the fi rst code in the remote control as described in the
ENTERING THE CODE DIRECTLY section.
Place the MELICONI remote control in front of the device, which should already be ON, and press the TV or ON/OFF
STB button (depending on the device being operated). If the device does NOT switch off, try setting the next code in
the SMS list on the remote control. When the device reacts, check whether the other buttons are operating correctly
too. If they do, the remote control is ready to use. If they don’t, you are probably using an incorrect code intended
for a very similar device. At this point, ignore the SMS list and consult the MANUAL CODE SEARCH section to fi nd a
more suitable code.
Check that the other buttons (light blue) correspond to the functions of the original remote control; if not, it is
likely that the code found is incorrect, but is used for a very similar device, therefore repeat the procedure
from point 2
C1. MANUAL SEARCH (TV)
If you want to use the Speedy 210 combo to simultaneously control two different devices (TV + DECODER) follow
procedure C1 then procedure C2.
To control a single device (DECODER), follow only procedure C2.
To control a single device (DIGITAL/ANALOGUE TV), follow procedure C3.
If the manual search for the code is successful, obtain the code in use by following the DISPLAY CODE IN USE
procedure and make a note of it inside the battery cover.
NOTE: If you don’t receive an SMS on your mobile phone or if the message says ERROR / NO CODE, it means the system
was not able to process the data you sent. Do not try sending another SMS, instead set the code using the MANUAL
CODE SEARCH procedure.
1. Switch on the TV and select a programme
2. Simultaneously hold down the VOL + and VOL - buttons.
3. When the indicator light starts fl ashing, release the buttons
and briefl y press the ON/OFF TV button.
4. The indicator light fl ashes faster; the remote control is ready
for the search.
5. Point the remote control at the TV. Slowly press and release
the ON/OFF TV button several times, stopping when the TV
is switched off (you may need to press the button several
dozen times).
6. When the device has switched off press the OK button.
Three long fl ashes indicate that the operation was completed
correctly.
TV
TV
OK